Dear all,
The po receipt program is customized. while receiving it checks if standard cost is zero or not ,if standard cost is zero then it prompts message that "Standard cost for the item is zero" and ideally it should not create any receiver for that. As expected the program it is showing error message . But if we press F4 it creates entry in prh_hist , but it works fine for enter & F1 . Becase there is a command stop just after message is executed by pressing F1 or enter. Due to this program works fine. But if we press F4 system does not execute that command hence program fails.
Kindly help on the same. Please.......
The program structure look like:
on write of prh_hist:
------
-----
if ----- then
do:
message "error: standard cost is zero" .
pause.
bell.
stop.
end. /* end of if */
end. /* end for on write of prh_hist */
The po receipt program is customized. while receiving it checks if standard cost is zero or not ,if standard cost is zero then it prompts message that "Standard cost for the item is zero" and ideally it should not create any receiver for that. As expected the program it is showing error message . But if we press F4 it creates entry in prh_hist , but it works fine for enter & F1 . Becase there is a command stop just after message is executed by pressing F1 or enter. Due to this program works fine. But if we press F4 system does not execute that command hence program fails.
Kindly help on the same. Please.......
The program structure look like:
on write of prh_hist:
------
-----
if ----- then
do:
message "error: standard cost is zero" .
pause.
bell.
stop.
end. /* end of if */
end. /* end for on write of prh_hist */
