chfbottlewasher
New Member
Hello, I am designing a screen that has 2 selection lists in it. I want them to be list-pairs, and start out blank. Then I will populate them at run-time.
If I designate them as list-items, everything goes smoothly. However, when I thry to use List-pairs, it I leave the list items blank, it changes the type back to list-items. If I manually change the code to list-pairs, when I open the code, it gives errors, and states it must be list-items. The only work-around I have found is to specify a list-pair. I don't want to do that, I want the set blank until I load it up.
Any ideas?
Thanks!
If I designate them as list-items, everything goes smoothly. However, when I thry to use List-pairs, it I leave the list items blank, it changes the type back to list-items. If I manually change the code to list-pairs, when I open the code, it gives errors, and states it must be list-items. The only work-around I have found is to specify a list-pair. I don't want to do that, I want the set blank until I load it up.
Any ideas?
Thanks!