[Progress Communities] [Progress OpenEdge ABL] Forum Post: RE: Configuring -mmax on PASOE

Status
Not open for further replies.
T

tim

Guest
The way the documentation states it is misleading (a hold-over from very early when the memory was pre-allocated up front). Since around version 7, the AVM only allocates the -mmax memory as it needs it. I'll enter a doc bug. Your application will begin to swap when it hits the -mmax amount used for r-code. What Frank says is true about the misconception. -mmax needs to be tuned for the reasons he stated. If you put your procedures in a memory mapped procedure library (recommended), then the PASOE agent will not use any -mmax.

Continue reading...
 
Status
Not open for further replies.
Top