Forum Post: RE: failed to load image

  • Thread starter Thread starter gabriel.lucaciu
  • Start date Start date
Status
Not open for further replies.
G

gabriel.lucaciu

Guest
Hi, I have found the following article on Progress Knowledgebase: knowledgebase.progress.com/.../000042630 Normally, in 11.3.2 your problem should have already been solved. But might be that the solution will solve your problem too: Re-register the prox.dll in the %DLC%\bin folder of the OpenEdge 11.3 installation: - Open a proenv prompt - Run the command "regsvr32 %DLC%\bin\prox.dll" .

Continue reading...
 
Status
Not open for further replies.
Back
Top