B
Bourgmaj
Guest
I am appalled to see that in the new tools, we lose the very useful functionalities which existed before. Thank you for your answer. From: Mike Fechner [mailto:bounce-mikefechner@community.progress.com ] Sent : 05 June 2014 11:38 To: TU.OE.General@community.progress.com Subject: [Technical Users - OE General] AW: AW: Procedure Editor in OpenEdge studio 13.2 for Windows 64 bits AW: AW: Procedure Editor in OpenEdge studio 13.2 for Windows 64 bits Reply by Mike Fechner Sorry – usually when people complain about the procedure editor, it’s that they have just installed the Progress Developer Studio license. My guess is, that the slick editor Active X Control required for the “fancy” editor features is not available for 64 bit and Progress falls back to a plain editor widget. Von: Bourgmaj [ mailto:bounce-Bourgmaj@community.progress.com ] Gesendet: Donnerstag, 5. Juni 2014 11:31 An: TU.OE.General@community.progress.com Betreff : RE: [Technical Users - OE General] AW: Procedure Editor in OpenEdge studio 13.2 for Windows 64 bits RE: AW: Procedure Editor in OpenEdge studio 13.2 for Windows 64 bits Reply by Bourgmaj I installed an OpenEdge Studio license. Sorry but I don’t know what PSDN does mean … From: Mike Fechner [ mailto:bounce-mikefechner@community.progress.com ] Sent : 05 June 2014 11:26 To: TU.OE.General@community.progress.com Subject: [Technical Users - OE General] AW: Procedure Editor in OpenEdge studio 13.2 for Windows 64 bits AW: Procedure Editor in OpenEdge studio 13.2 for Windows 64 bits Reply by Mike Fechner You need to install an OpenEdge Studio license in parallel. Are you on a PSDN subscribption license? Von: Bourgmaj [ mailto:bounce-Bourgmaj@community.progress.com ] Gesendet: Donnerstag, 5. Juni 2014 11:24 An: TU.OE.General@community.progress.com Betreff: [Technical Users - OE General] Procedure Editor in OpenEdge studio 13.2 for Windows 64 bits Procedure Editor in OpenEdge studio 13.2 for Windows 64 bits Thread created by Bourgmaj I just installed OpenEdge studio 13.2. Until now I used Provision 9.1. I was very surprise to see that the procedure editor in OpenEdge does not recognize the key words like in my old Provision. Is it normal or have I something to do to recover the functionnalities of the old version ? Thank you Stop receiving emails on this subject. Flag this post as spam/abuse. Stop receiving emails on this subject. Flag this post as spam/abuse. Stop receiving emails on this subject. Flag this post as spam/abuse. Stop receiving emails on this subject. Flag this post as spam/abuse.
Continue reading...
Continue reading...