Forum Post: MIndFusion - Exception has been thrown by the target of an invocation

  • Thread starter Thread starter tbergman
  • Start date Start date
Status
Not open for further replies.
T

tbergman

Guest
I want to add a flow chart type of view to our application. I downloaded a set of controls from MindFusion and installed them. It appears their installation does not add the controls to the GAC so I copied the DLLs to my project, added assembly references and successfully added the controls to the toolbox in visual designer. The error above occurs when I try to drag a DiagramView control to my form. A Kbase search reports that the same error can occur with the Infragistics controls if they are not properly licensed. I suspect this may be the problem as I downloaded a trial version. The controls work fine in Visual Studio. Is there a way to get these working in Progress? Are there similar controls others have used in Progress that you can recommend? Thanks, Tom

Continue reading...
 
Status
Not open for further replies.
Back
Top