M
Marian Edu
Guest
nice explanation, would it be too hard to have it documented? even if it was in some release notes not everyone is actually reading those 
On 06/13/2014 10:09 AM, Lieven De Foor wrote: From: Lieven De Foor Post: RE: How to set SOCKET:CONNECT() timeout value Posted in: OpenEdge Development Link: http://community.progress.com/technicalusers/f/19/p/10777/40231.aspx#40231 Thanks to both, I just got a reply from tech support mentioning the -clientConnectTimeout parameter too: There is an undocumented parameter for the CONNECT method which is "-clientConnectTimeout ". It needs to be added as part of the connection string. is the number of milliseconds to wait before timing out the connection attempt. This parameter was introduced for SSL connections in OpenEdge 10.2B07 or OpenEdge 11.2.0 or later. Support for non-SSL connections was added in OpenEdge 11.3. Please note that since OpenEdge 11, two connection attempts are made before the connection attempt is aborted. So please keep this in mind when calculating your timeout. -- You were sent this email because you opted to receive email notifications when someone created a new thread. To unsubscribe from: - ...only this thread, disable notifications at http://community.progress.com/technicalusers/f/19/p/10777/40231.aspx#40231. - ...all email notifications from Progress Community, navigate to "Settings", click on the "Email" tab, then under the "Email Configuration" section, set Send Notifications to "No". -- m.edu keep it simple http://www.ganimede.ro http://ro.linkedin.com/in/marianedu medu@ganimede.ro mobile: +40 740 036 212 skype: marian.edu
Continue reading...
On 06/13/2014 10:09 AM, Lieven De Foor wrote: From: Lieven De Foor Post: RE: How to set SOCKET:CONNECT() timeout value Posted in: OpenEdge Development Link: http://community.progress.com/technicalusers/f/19/p/10777/40231.aspx#40231 Thanks to both, I just got a reply from tech support mentioning the -clientConnectTimeout parameter too: There is an undocumented parameter for the CONNECT method which is "-clientConnectTimeout ". It needs to be added as part of the connection string. is the number of milliseconds to wait before timing out the connection attempt. This parameter was introduced for SSL connections in OpenEdge 10.2B07 or OpenEdge 11.2.0 or later. Support for non-SSL connections was added in OpenEdge 11.3. Please note that since OpenEdge 11, two connection attempts are made before the connection attempt is aborted. So please keep this in mind when calculating your timeout. -- You were sent this email because you opted to receive email notifications when someone created a new thread. To unsubscribe from: - ...only this thread, disable notifications at http://community.progress.com/technicalusers/f/19/p/10777/40231.aspx#40231. - ...all email notifications from Progress Community, navigate to "Settings", click on the "Email" tab, then under the "Email Configuration" section, set Send Notifications to "No". -- m.edu keep it simple http://www.ganimede.ro http://ro.linkedin.com/in/marianedu medu@ganimede.ro mobile: +40 740 036 212 skype: marian.eduContinue reading...