Forum Post: Procedure Editor in OpenEdge studio 13.2 for Windows 64 bits

  • Thread starter Thread starter Bourgmaj
  • Start date Start date
Status
Not open for further replies.
B

Bourgmaj

Guest
I just installed OpenEdge studio 13.2. Until now I used Provision 9.1. I was very surprise to see that the procedure editor in OpenEdge does not recognize the key words like in my old Provision. Is it normal or have I something to do to recover the functionnalities of the old version ? Thank you

Continue reading...
 
Status
Not open for further replies.
Back
Top