I would like to find the table(s) and fieldname(s) that are being written to by a program.
In this case, I only have the compiled .r code.
Is it possible to run this program from within a wrapper, where there is something like:
{pseudocode}
ON WRITE OF ANY TABLE DO:
MESSAGE TABLENAME FIELDNAME.
END.
Any hint is welcome, thanks up front
In this case, I only have the compiled .r code.
Is it possible to run this program from within a wrapper, where there is something like:
{pseudocode}
ON WRITE OF ANY TABLE DO:
MESSAGE TABLENAME FIELDNAME.
END.
Any hint is welcome, thanks up front